June 2014 Fuji Xerox ApeosPort-V C7775/C6675/C5575/C4475 /C3375/C3373/C2275 DocuCentre-V C7775/C6675/C5575/C4475 /C3375/C3373/C2275 Series Controller Software. For information on downloading Drivers and Softwares in your country, please contact Fuji Xerox in your region. Fuji Xerox in Your Country/Region (including Exclusive dealer).

• • • • • • Installation Installation of Fuji Xerox Multifunction Device (MFD)/Plotter requires your company network point. Please make sure that the network point is ready and prepare a network cable upon the arrival of Fuji Xerox Installation Engineer.

This guideline would guide you to prepare for the necessary information required based on the device settings you prefer. Please get ready this information before the installation date to facilitate the installation process.

If your IT representative can be present when our Fuji Xerox Installation Engineer arrives, that would highly increase the efficiency of the installation process. Installation of MFD/Plotter Please prepare the following information of your company network for the installation of MFD/Plotter: • IP address • Subnet Mask • Gateway • DNS and WINS (if applicable) Print function Our engineer would assist to install print driver on 10 personal computers (PCs). If the print drivers are being shared from the server, our engineer would assist your IT representative with the loading of these drivers. How To Install Cracked Touchpad Apps Mac. For MFD, please decide on the desired print setting up front (e.g.

Default printing in colour, black and white, A4-sized, two-sided and etc) and communicate this to our Installation Engineer. Scan function Fuji Xerox MFD can support the following scan settings: • Scan to network • Scan to shared folder • Scan to email Fuji Xerox Plotter can support the following scan settings: • Scan to network • Scan to shared folder (supported by DW3035 and DW6055 only) Please decide on the preferred setting and prepare the information required. 3. Once confirmed, complete the registration form. You will then be contacted by our support team to set up your new service. For support, please call 1800 028 962. User Training Every new MFD/Plotter installed is entitled to one free user training session. We would send a trainer to your company to conduct the training.

Maximum of 8 users are recommended for each training session so that users can have clear view of the demonstration. Training duration for MFD would be around 1 - 1.5 hours whereas Plotter would take 4 hours approximately. Please note that this free training session is only applicable for 3 months upon the installation of the MFD/Plotter. Charges will apply if training session is requested after the stated period. Amendment and Cancellation Please note that if we are unable to complete the installation due to site issue(s), there may be a charge of SGD$150 (exclusive of GST) for Fuji Xerox Installation Engineer to make additional trip back to your premises to complete the installation. Manual Impresora Hp Deskjet 610c. Amendment/Cancellation of the Installation/Training appointment made less than 3 working days would incur a fee of SGD$150.